Shenzhen boda jingke biotechnology co. LTD
address：5th floor,okwei building, 447 donghai avenue west, yantian district,shenzhen
The working principle of multi-point magnetic agitator is that the micro-motor drives the high-temperature resistant strong magnet to rotate and generate the rotating magnetic field to drive the agitator in the container to achieve the purpose of stirring the liquid in the container.
The working principle of multi-point magnetic agitator is that the micro-motor drives the high-temperature resistant strong magnet to rotate and generate the rotating magnetic field to drive the agitator in the container to achieve the purpose of stirring the liquid in the container. At the same time, the solution can be heated synchronously, so that the solution can be fully mixed and reacted at the set temperature. Multipoint magnetic agitator is widely used in biology, medicine, chemistry, chemical industry and other fields.
Multipoint magnetic agitator is used for laboratory instrument of liquid mixing. It is mainly used for stirring or heating at the same time to stir liquid or solid-liquid mixture with low viscosity. Its basic principle is to use the magnetic field of the same repel, opposites attract principle, using magnetic field to push the magnetic agitator placed in the container for circular movement, so as to achieve the purpose of stirring liquid. With the heating temperature control system, it can heat and control the sample temperature according to the specific experimental requirements, maintain the temperature conditions required by the experimental conditions, and ensure that the liquid mixture meets the experimental requirements.
The following points should be paid attention to in the use of multipoint magnetic agitator:
1. Start work with mouth: in case of failure of electric agitator, do not start work in an emergency, but inquire about the process before and after the failure and the failure phenomenon. For unfamiliar equipment, should also be familiar with the circuit principle and structure characteristics, comply with the relevant rules. Before disassembly, it is necessary to fully understand the function, position, connection mode of each electrical component and the relationship with other surrounding devices. In the absence of assembly diagram, it is necessary to make sketches and mark them while disassembling.
2. First external, then internal: check whether the equipment has obvious cracks and defects, understand its maintenance history and service life, and then check the inside of the machine. Before disassembly, the surrounding fault factors should be eliminated and the disassembly can only be conducted after the internal fault is determined. Otherwise, blind disassembly may lead to the worse repair of the equipment.
3, mechanical electrical: only in the determination of mechanical parts without fault, electrical inspection. When checking the circuit fault, the detection instrument should be used to find the fault location, and after confirming the fault without bad contact, the operation relationship between the circuit and the machine should be checked in a targeted way to avoid misjudgment.
4, first static and then dynamic: when the equipment is not powered on, judge the quality of the button, transformer, thermal relay and fuse of the electrical equipment, so as to determine the fault location. Power test, listen to its sound, measure parameters, judge the fault, zui after maintenance. If the three-phase voltage value cannot be judged when the motor is out of phase, we should listen to it and measure each relative voltage separately to judge which phase is out of phase.
5. Cleaning before maintenance: for electrical equipment with heavy pollution, clean the buttons, wiring points and contact points to check whether the external control keys are out of order. Many faults are caused by dirt and conductive dust blocks.