Daily inspection of the nanometer laboratory heating plate is indispensable

For the nano laboratory heating plate, the correct operation method and daily necessary maintenance have a very important impact on its service life, the next small series to briefly introduce the nano laboratory heating plate daily maintenance points, I hope the following introduction can bring help to your later use.

1. Before each use, check whether the wires of the heating plate of the nanometer laboratory are connected properly to ensure the normal power supply. Connect the power and turn on the power.

2. Press the temperature setting button (some electric heating plates are equipped with remote controller) to set the desired temperature. At this time, the nanometer laboratory heating plate starts heating until the digital display reaches the set temperature.

3. After using the nanometer laboratory heating plate, turn off the power, let the electric heating plate naturally cool to room temperature, and clean the table, after cleaning the table should not be placed idle things.

4. During the use of the heating plate in the nanometer laboratory, the equipment should be used at the specified voltage, and the contact surface at the installed position should be flat and without concave and convex phenomenon. If it is not used for a long time, it should be placed dry to avoid being immersed in water and affecting its insulation performance.

5. Conduct functional checks on the operation of the nanometer laboratory heating plate every six months.

6. Check regularly whether the heating plate of the nanometer laboratory is intact, whether the power cord is connected tightly, whether the surrounding area of the board is clean, and whether there are inflammables and inflammable articles.

7. Switch on the power, and the heat alarm and digital display lights up, and the display is normal. When heating, the indicator light flashes to warn the user of the high temperature of the heating plate. The digital display increases with the increase of heating time, and the value increases until the set temperature is reached.

8. Check the temperature control degree of the heating plate in the nanometer laboratory. Press the temperature setting button and set the temperature at 120℃. All the above items are qualified, indicating that the instrument is normal and can be used normally.

9. The custodian of the heating plate in the nanometer laboratory is responsible for supervising whether the operation of the instrument conforms to the regulations, carrying out regular maintenance and maintenance of the instrument, and ensuring that the instrument used is within the validity period of verification.

If you want to know more information about the heating board of nanolab, please continue to pay attention to shenzhen boda jingke biotechnology co., LTD.